EasyManuals Logo

Intel RS2BL080 - RAID Controller User Manual

Intel RS2BL080 - RAID Controller
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Intel® RAID Controller RS2BL080 Hardware User’s Guide 3
All operating systems supported by the RAID controller may not be supported by your
server board. To verify compatibility, see the Tested Operating System List for your server
board at http://support.intel.com/support/motherboards/server/.
To make sure the RAID controller supports your operating system, refer to the Tested
Hardware and Operating System List for the Intel
®
RAID Controller RS2BL080.
Usability
The card ships with both a standard and a low-profile bracket.
Small, thin cabling with up to 6.0 Gbps serial, point-to-point data transfer rates
Support for non-disk devices and mixed capacity drives
Support for intelligent XOR RAID levels 0, 1, 5, 6, 10, 50, and 60
Dedicated or global hot spare with auto rebuild if an array drive fails
User-defined stripe size per drive: 8, 16, 32, 64, 128, 256, 512, or 1024 KB
Advanced Array configuration and Management Utilities provides:
Online Capacity Expansion (OCE) adds space to existing drive or new drive.
See Appendix A for limitations on OCE and RAID migration.
Online RAID level migration (upgrade of RAID mode may require OCE).
Drive migration
Drive roaming
No reboot necessary after expansion
Load Balancing
Upgradeable Flash ROM interface
Allows for staggered spin up, hot-plug, and lower power consumption
User-specified rebuild rate (percent of system resources to use from 0-100%)
Caution: Exceeding 50% rate may cause operating system errors due to waiting for
controller access.
Background operating mode can be set for Rebuilds, Consistency Checks,
Initialization (auto restarting Consistency Check on redundant volumes), Migration,
OCE, and Patrol Read.
Allows mixed connections to SAS targets or SATA II targets
Note: Intel recommends that you carefully assess any decision to mix SAS and SATA drives
within the same virtual drive. Although you can mix drives within the same virtual drive,
Intel strongly discourages the practice. However, you should never mix SAS and SATA
drives within the same enclosure.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intel RS2BL080 - RAID Controller and is the answer not in the manual?

Intel RS2BL080 - RAID Controller Specifications

General IconGeneral
BrandIntel
ModelRS2BL080 - RAID Controller
CategoryComputer Hardware
LanguageEnglish

Related product manuals