INTELECT LEGEND STIM USER MANUAL
4
9. WARNING: Keep electrodes separated during treatment. Electrodes in contact with each other could result in improper
stimulation or skin burns.
10. WARNING: For continued protection against fire hazard, replace fuses only with ones of the same type and rating.
11. WARNING:
Make certain that the unit is electrically grounded by connecting
only to a grounded electrical service receptacle
conforming to the applicable national and local electrical codes.
12. WARNING: This device should be kept out of the reach of children.
13. WARNING: Care must be taken when operating this equipment around other equipment. Potential electromagnetic or other
interference could occur to this or to the other equipment. Try to minimize this interference by not using other
equipment in conjunction with it.
14. CAUTION: This unit should be operated, transported and stored in temperatures between 59° F and 104° F (15° C and 40° C),
with Relative Humidity ranging from 30%- 60%.
Before administering any treatment to a patient you should become acquainted
with the operating procedures for each mode of
treatment available, as well as the indications, contraindications, warnings and precautions. Consult other resources for additional
information regarding the application of electrotherapy.
Installation
Initial Setup Instructions
Remove the Intelect
®
Legend Stim unit and any additional items ordered from the carton and inspect for damage that may
have
occurred during shipment. Check the voltage rating on the serial decal located
on the bottom of the unit. Plug the
system power supply in to a 100 Volt to 220-240 Volt AC outlet, as required.
To Next Page
Loading...
