3.2 NORMAL Mode:
The Normal mode produces a continuous train of impulses. The stimulation
parameters are not automatically interrupted nor varied in any way. In this mode, the
pulse rate (from 2 to 150Hz) and pulse width (from 60 to 250µs) are fully adjustable.
The normal mode is quite versatile because it may be applied with a variety of rate
and width settings.
3.3 Modulation Mode:
Pulse width shows decrease/ increase cycle of variation. For example, if pulse width is
set for the maximum output value (250µs), pulse width will decrease from 250µs to
125µs and then increase back to 250µs again in period of 4 seconds.
The mode switch offers three stimulation modes. The mode switch is located
under the front lid cover and you can shift the "MODE" switch to adjust the
mode.
Be sure that when adjusting these stimulation modes, the intensity (Amplitude)
output controls are set to the minimum output positions.
3.1 BURST Mode:
The burst mode provides a "burst" of seven pulses. There are two bursts
delivered per second.
3.STIMULATION MODES
8
7
To Next Page
Loading...
