Intelligent Home CAT-5 Series User Manual

To be able to do programming, rst get into the programming mode.
9.2 Programming
9.2.1 Get into the system
-17-
1. Press (FN) + password (4 digits) + (ENTER). Note: default password is 1234
2. The door station will sound a long beep and DOOROPEN LED will flash slowly. You
have 7s to enter the password, otherwise system will exit automatically.
3. If wrong password was used the door station will say “Sorry, wrong number. Please try
again”. Repeat step 1 with correct password.
4. To exit programming mode, press (EXIT). Or system will exit automatically if no activity
in 2min.
5. During programming bell button and service button are not responsive.
1. Press FN + new password ( 4 digits) + repeat new password + ENTER
2. The door station will sound a long beep and DOOROPEN LED will ash slowly.
3. If you hear “Sorry, wrong number. Please try again” then repeat step 1
Note:
Please memorize your new password. If you forget your new password please call
Distributor for help to reset a password
9.2.2 Change password

Intelligent Home CAT-5 Series Specifications

General

Brand	Intelligent Home
Model	CAT-5 Series
Category	Intercom System
Language	English