6.3 electrodes
1) Use the device only with the leads and electrodes provided by the
manufacturer. Use only the electrode placements and stimulation
settings prescribed by your physician or therapist.
2) It is recommended that, at minimum, 1.5"X1.5" self-adhering
square electrodes are used at the treatment area.
3) Inspect your electrodes before every use. Replace electrodes as
needed. Reusable electrodes may cause slight skin irritation, lose
adhesion and deliver less stimulation if overused.
To use these electrodes:
1) Attach the electrode to the lead wire.
2) Remove the protective backing from the electrode surface. Do not
throw away the protective backing because it is reused after the
treatment session has been completed.
3) Place the tacky surface to the prescribed skin area by pressing
the electrode firmly against the skin.
To remove your electrodes:
1) Lift the corner of the electrode and gently remove it from the skin.
2) Apply the protective backing to the tacky side of the electrode.
Place the electrode on the side of the protective backing that is
labeled with the word on.
3) It may be helpful to improve repeated application by spreading a
few drops of cold water over the adhesive and turn the surface up
to air dry. Over Saturation with water will reduce the adhesive
properties.
To Next Page
Loading...
Need help?
General
