15
Intenza Treadmills Handbook. Setup: Checking The Belt And Power Switch
After the Intenza Treadmill has been installed and stabilised, the belt must be checked to
confirm proper tracking.
Firstly, ensure the power cord is plugged into a suitable outlet. And secondly, turn on the treadmill. Stand on the side landing of the
treadmill and straddle the belt. To start the belt, press the 4mph button. If the striding belt appears off—centre, please refer to section
How To Align The Running Belt.
Checking The Belt
The power switch is located on the front panel at the base of Intenza Treadmill.
The ON/OFF switch has 2 positions:
Power Switch
“ ” represents ON and “ ” represents OFF.
CENTERED
OFF—CENTERED
EN
To Next Page
Loading...
