Intenza 450TI2S - How To Tension The Running Belt

25
Intenza Treadmills Handbook. Maintenance. How To Tension The Belt
When walking on the running platform, if a slipping sensation is experienced the belt has
stretched and is slipping across the rollers.
The running belt will stretch over time. This is a normal and common adjustment to make on any treadmill. To eliminate any slipping
please follow the instructions below—
How To Tension The Running Belt
1 Tension both bolts on the rear roller 1/4 turn clockwise.
2 Try the treadmill at 1.0 km/h (0.5 mph) speed to check for slipping.
3 Try the treadmill again to check for slipping.
IF IT IS A MINOR ADJUSTMENT
............................................................................................................................... ....................................................................
1 Place 4 pieces of tape, 1,000mm apart, on both edges of the running belt.
2 Tighten the tensioning bolts until the distance between the tapes are increased to 1,005mm (39.75 inches).
3 Try the treadmill again to check for slipping.
IF IT IS A SIGNIFICANT ADJUSTMENT
............................................................................................................................... ....................................................................
1,000mm
1,000mm
1,005mm
1,005mm
EN
PLEASE NOTE Make adjustments in 1/4 turn. Do not
exceed one full turn of the Adjusting Screws. Over
tightening the belt can significantly shorten the belt life.