MULTI P.A COMBINATION
12
SYSTEM-2240G
How to Use CD / MP3 Player
How to Use CD / MP3 Player
Power ON/OFF
- When there does not exist a disc upon power-on:
1. If power is applied to CDP, message is displayed, keeping a standby status.
2. Push the CD softly until the tray pulls on the CD.
3. While the unit reads CD, message is displayed.
4. For MP3 CD, message is displayed.
5. After the unit searches the music information on a CD (for about 10 seconds), message is
displayed, keeping a standby status.
6. Press the switch to start operation. Then playback is started from the first song on a CD.
- When there exists a disc upon power-on:
1. While the unit reads CD, message is displayed.
2. For MP3 CD, message is displayed.
3. After the unit searches the music information on a CD, message is displayed, keeping a standby
status.
4. Press the switch to start operation. Then playback is started from the first song on a CD.
- LCD DISPLAY OFF
1. If press STOP switch in case of NO DISC was registered in LCD DISPLAY window, LED power turns off.
2. Please press any key in case of turns on LCD DISPLAY power again or push the CD to DISC TRAY.
Functions
- PLAY Function
1. Insert a CD, and press switch after CD information is displayed.
2. When MP3 CD is played, is displayed on the left top of LCD display.
- PAUSE Function
1. If you stop playing at the current position temporarily, press switch.
2. While this pause function is active, message is displayed.
3. If you press switch once more, the pause function is released and the unit starts playing from
the current position.
4. While the pause function is active, you can move between directories or tracks. If, however, you make
such movement, the pause function is released, and the unit starts playing automatically.
- SCAN Function
1. You can use this function to search a desired song by hearing the first part of each track.
2. If you press switch in the course of playing, the unit plays the beginning part of each subsequent
track for 10 seconds.
3. If you press switch in a stop status, message is displayed, and then if you press PLAY/
PAUSE switch, the unit plays the beginning part of each track for 10 seconds from the first track of
a CD.
4. While the track is performing a search function, message is displayed.
5. If you find a desired track, press switch once more to stop searching and start playing.
6. In case of MP3, if you long-press switch for more than 1 second, message is display-
ed, and the unit plays the beginning part of each file in the directory for 10 seconds.
READING CD ROM
S -- PAUSE
D -- INT NO.
D -- INT NO.
INTRO
S -- CDP-- -- --
PLAY/PAUSE
MP3
PLAY/PAUSE
PLAY/PAUSE
PLAY/PAUSE
SCAN
STOP
SCAN
SCAN
SCAN
CD STOP
S -- CDP-- -- --
READING CD ROM
NO DISC
NO DISC
CD STOP
To Next Page
Loading...
Need help?
General
