Inter-Tel GLX - System and Station Speed Dialing; Station Speed Dialing

SYSTEM AND STATION SPEED DIALING
STATION SPEED DIALING
Up to nine station speed-dial numbers can be stored by keyset
users for their personal use.
They are identified by a one-digit
memory location code (l-9).
Location code 1 is also used for the
call forwarding feature.
To store or change station speed-dial numbers:
Note: If you make a mistake while dialing the number, press any
line key. If you press an invalid key or dial an invalid loca-
tion code, you hear four fast tones and the keyset is returned to
the idle state. In either case, the original number is retained.
(1) While on hook, press the SPDL key. The SPDL key flutters.
(2) Dial the one-digit memory location code (l-9).
(3) Dial the telephone number (up to 32 digits, including the
pauses). To include pauses in the number, press the SPDL key
once for each pause. If more than 32 digits are dialed, only
the last 32 digits are retained.
(4) Lift and replace the handset. You hear a confirmation tone
and the SPDL key is unlit.
To dial station speed-dial numbers:
(1) Lift the handset and press an unlit line key.
(2) Press the SPDL key. The SPDL key lights.
(3) Dial the one-digit memory location code (l-9). The number is
dialed and the SPDL key is unlit. If you dial an invalid
location code, you hear a busy signal and the C.O. line is
placed on hold.
To erase a station speed-dial number without entering a new
number:
(1) While on hook, press the SPDL key. The SPDL key flutters.
(2) Dial the memory location code (l-9) to be erased.
(3) Press the SPDL key again.
(4) Lift and replace the handset. You hear a confirmation tone
and the SPDL key is unlit.
GLX Owner's Guide (Issue 1, 11/85)
Page 21