SYSTEM AND STATION SPEED DIALING
SYSTEM SPEED DIALING
Up to 30 system speed-dial numbers can be stored from the atten-
dant's keyset for use by any keyset user.
They are identified by
a three-digit memory location code (001-030).
To store or change system speed-dial numbers:
Note : System
speed-dial numbers can only be stored or changed
from the attendant's keyset. If you make a mistake while dialing
the number, press any line key.
If you press an invalid key or
dial an invalid location code, you hear four fast tones and the
keyset is returned to the idle state. In either case, the origi-
nal number is retained.
(1) While on hook, press the SPDL key. The SPDL
key
flutters.
(2) Dial the three-digit memory location code (001-030).
(3) Dial the telephone number (up to 32 digits, including the
pauses). To include pauses in the number, press the SPDL key
once for each pause. If more than 32 digits are dialed, only
the last 32 digits are retained.
(4) Lift and replace the handset.
You hear a confirmation tone
and the SPDL key is unlit.
To dial system speed-dial numbers:
(1) Lift the handset and press an unlit line
key.
(2) Press the SPDL key. The SPDL key lights.
(3) Dial the three-digit memory location code (001-030).
The
number is dialed and the SPDL key is unlit.
If you dial an
invalid location code,
you hear a busy signal and the C.O.
line is placed on hold.
To erase a system speed-dial number without entering a number:
Note :
System speed-dial numbers can only be erased at the atten-
dant's keyset (intercom number 10).
(1) While on hook,
press the SPDL key. The SPDL key flutters.
(2) Dial
the three-digit memory location code (001-030).
(3) Press the SPDL key again.
(4) Lift and replace the handset.
You hear a confirmation tone
and the SPDL key is unlit.
GLX Owne;'s Guide (Issue 1, 11/85)
Page 22
To Next Page
Loading...
