AA222 Additional Information Page 18
License
A
AUD key. When pressing the button a pop-up window opens in which you can enter
a new license key for the audiometry module. The new license key is activated by pressing the
button. The previous license key will not be changed if the new key is not a valid key.
B
IMP key. When pressing the button a pop-up window opens in which you can enter a
new license key for the impedance module. The new license key is activated by pressing the
button. The previous license key will not be changed if the new key is not a valid key.
Light
C
You can alter the Display light by holding the button and rotating the wheel. You will
see the brightness of your screen change accordingly.
D
You can alter the LED light by holding the button and rotating the wheel. You will see
the brightness of the LEDs around the Enter button change accordingly. Note that the LED in the
probe system cannot be adjusted.
Session settings
E
Keep Session on Save will keep the session on the device when pressing save session.
System
F
When pressing the button while Date and time is selected you can manually alter the
date and time.
The following window will pop up
Use the wheel to select day, month, year, hour and minutes. Use the and
buttons to adjust the number. Press the button to keep the changes and set the date
and time, or press the button to reject any changes made.
When the AA222 is connected to the Diagnostic suite, your PC automatically updates the date
and time.
Printer
G
Under Printer type you can select which printer is connected to the USB port of your AA222. By
default, the Sanibel MPT-III thermal printer is selected. The list below shows the currently
supported printers:
To Next Page
Loading...
Need help?
General
