Air Fx Irrigator Instructions for Use - US Page 17
6. Disconnect the syringe from the tubing and squirt any distilled or demineralized water into a waste
container.
7. Reconnect the syringe tubing and repeat steps 3 to 7 to draw the distilled or demineralized water
out again. Repeat this drawing process until all of the distilled or demineralized water is removed
from the internal lines, until only air is drawn into the syringe.
8. Set the Fill / Drain Valve to the Run position.
9. Disconnect the syringe and tubing. The tubing can be removed by pushing in the gray gasket around
the tubing with your finger nails while pulling on the tubing to remove.
10. Screw the cap back on the water reservoir.
To Next Page
Loading...
