How to resolve 'Fit Error Cannot Obtain L' on Interacoustics Tools?
If you see 'Fit Error Cannot Obtain L' on Interacoustics Tools during a DP test, the desired level (L1 or L2) cannot be obtained within allowable limits. Refit the probe and retry the test. You may also need to replace the probe tube.
What to do if Interacoustics OtoRead Medical Equipment displays 'Printer Paper Out!'?
Replace the paper roll in the printer.
What to do if Interacoustics OtoRead displays 'Power Low!'?
The battery must be charged before you can perform additional tests.
What to do if my Interacoustics OtoRead displays 'Memory Full!'?
You will need to clear the memory before performing any additional tests.
How to troubleshoot 'Device Not Responding' error on Interacoustics Tools?
If your Interacoustics Tools shows 'Device Not Responding', the printer is not responding to queries from the instrument. Check the printer status, awaken the printer from sleep mode, or charge the printer battery if necessary.
What does 'Due for Service' mean on Interacoustics Tools?
If Interacoustics Tools displays 'Due for Service', it indicates that calibration of the instrument is recommended. This message will appear upon the calibration due date set in the device and appears during device startup once per day.
How to fix frozen display on Interacoustics Tools?
If the Interacoustics Tools display is frozen and the instrument isn't responding to button presses, press and hold the DOWN arrow button for 10 seconds to force the instrument to power off. Powering the instrument back on should reset and restore normal function.
How to troubleshoot printing issues with Interacoustics Tools?
If the Interacoustics Tools results will not print, first check the printer status by turning the printer on or waking it from sleep mode by pressing the large button. If the printer does not turn on, plug in the power supply to charge the battery. Ensure the printer has paper. If paper comes out but there is no text, the paper is in backwards. You can also press the large printer button twice, rapidly, to run a demo print.
How to fix 'Fit Error Too Low' on Interacoustics OtoRead Medical Equipment?
Refit the probe in the patient’s ear and retry the test. If the issue persists, replace the probe tube.
How to fix 'Fit Error Cannot Obtain P' on Interacoustics Medical Equipment?
Refit the probe in the patient’s ear and retry the test. If the issue persists, replace the probe tube.
Covers electrical, explosion, EMC, environmental safety, and general cautions.
Details instrument components, probe, hook, neckstrap connections.
Instructions for cradle installation, use, and battery charging procedures.
General precautions, control panel, powering device on/off, and battery status.
Explains LED indicators, daily system checks, and patient preparation steps.
Guidance on ear tip selection, attachment, removal, and probe tube management.
Lists common problems and their solutions for the instrument and printer.
General| Brand | Interacoustics |
|---|---|
| Model | OtoRead |
| Category | Medical Equipment |
| Language | English |
To Next Page
