What to do if Interacoustics OtoRead Medical Equipment displays 'Attach Probe'?
If the 'Attach Probe' message appears, check that the probe connector is fully seated in the socket. Try disconnecting and reconnecting the probe. If the issue continues, cycle the instrument power.
What to do if Interacoustics OtoRead does not turn on?
Ensure the DOWN arrow is pressed for a full second until the Yellow ‘TEST’ LED illuminates. Connect the charger, as shown in chapter 2.6.2, and confirm the blue ’Charging’ LED is slowly blinking. Wait at least 10 minutes before attempting to turn on the instrument again.
What to do if Interacoustics OtoRead Medical Equipment results will not print?
Check the printer status. Turn the printer on (wake from sleep mode) by pressing the large button. If the printer does not turn on, plug in the power supply to charge the battery. Be sure the printer has paper. If paper comes out of the printer but there is no text on the paper then the paper is in backwards. Press the large printer button twice, rapidly, to run demo print.
What to do if there is a printer error with Interacoustics Tools?
If the Interacoustics Tools printer is not responding, begin by checking the printer's status. If necessary, try resetting the printer or cycling its power to resolve the issue.
Covers electrical, explosion, EMC, environmental safety, and general cautions.
Details instrument components, probe, hook, neckstrap connections.
Instructions for cradle installation, use, and battery charging procedures.
General precautions, control panel, powering device on/off, and battery status.
Explains LED indicators, daily system checks, and patient preparation steps.
Guidance on ear tip selection, attachment, removal, and probe tube management.
Lists common problems and their solutions for the instrument and printer.
General| Brand | Interacoustics |
|---|---|
| Model | OtoRead |
| Category | Medical Equipment |
| Language | English |
To Next Page
