What does 'Fit Error Too High' mean on Interacoustics Tools?
If the Interacoustics Tools displays 'Fit Error Too High' during a DP test, the level of the calibration tone is too high. Refit the probe and retry the test. Replacing the probe tube may also help.
How to fix 'Fit Error Too Low' message on Interacoustics Tools?
If the Interacoustics Tools displays 'Fit Error Too Low' during a DP test, the level of the calibration tone is too low. Refit the probe and retry the test. You might also need to replace the probe tube.
What does 'Limit Error' mean on Interacoustics Tools?
If the Interacoustics Tools displays 'Limit Error', it indicates an overflow error during the calculation of the DFTs for a DP test. Repeat the test, or cycle the instrument power.
How to troubleshoot 'BT Error #xxx' on Interacoustics Tools?
If the Interacoustics Tools displays 'BT Error #xxx', check the status of the BT device (printer or PC) and attempt to connect to the BT device again.
What to do when Interacoustics Tools memory is full?
If the Interacoustics Tools displays 'Memory Full!', the maximum saved test limit has been reached. Clear the memory before performing additional tests.
What to do when Interacoustics Tools memory is almost full?
If the Interacoustics Tools displays 'Memory almost full', saved tests are within 5 tests of the maximum limit. Print or transfer test results to avoid interruption in testing.
What does 'Due for Service' mean on Interacoustics Tools?
If Interacoustics Tools displays 'Due for Service', it indicates that calibration of the instrument is recommended. This message will appear upon the calibration due date set in the device and appears during device startup once per day.
How to fix 'Fit Error Cannot Obtain P' on Interacoustics Medical Equipment?
Refit the probe in the patient’s ear and retry the test. If the issue persists, replace the probe tube.
What to do if Interacoustics OtoRead Medical Equipment displays 'Printer Paper Out!'?
Replace the paper roll in the printer.
What to do if Interacoustics OtoRead displays 'Power Low!'?
The battery must be charged before you can perform additional tests.
Covers electrical, explosion, EMC, environmental safety, and general cautions.
Details instrument components, probe, hook, neckstrap connections.
Instructions for cradle installation, use, and battery charging procedures.
General precautions, control panel, powering device on/off, and battery status.
Explains LED indicators, daily system checks, and patient preparation steps.
Guidance on ear tip selection, attachment, removal, and probe tube management.
Lists common problems and their solutions for the instrument and printer.
General| Brand | Interacoustics |
|---|---|
| Model | OtoRead |
| Category | Medical Equipment |
| Language | English |
To Next Page
