Interfit S1 - Accessorizing Your Interfit S1; Shipping Cover Usage; Light Modifier Compatibility

Accessorizing your S1
Shipping Cover
Every S1 ash head includes a protective shipping cover. The shipping cover offers protection to the glass
dome, ash tube, and LED modeling lamp during transportation and storage.
To remove the shipping cover, pull back on the modier quick release on the top of the ash unit to release
the mount lock. While holding back the release button, twist the shipping cover counterclockwise.
To replace the shipping cover back on the ash unit, insert the three prongs of the shipping cover into the
mount and rotate clockwise until you hear a click.
Bowens® Mount Modiers
Modifying the light from your S1 is key to creating dynamic images. The S1 can be used with any light
modier with a Bowens® mount.
To attach a Bowens® mount modier to the S1, simply insert the three prongs of the modier ring into the
mount and rotate clockwise until you hear a click. To remove the modier, pull back on the modier quick
release on the top of the ash unit to release the mount lock and rotate the modier counter-clockwise.
Softboxes
Softboxes’ variety of shapes and sizes allow for virtually endless lighting possibilities. The S1 utilizes a
modier mount that ts softboxes with Bowens® mount speed rings.
To attach a softbox with a Bowens® mount speed ring, simply insert the three prongs of the speed ring into
the mount and rotate clockwise until you hear a click. To remove the softbox, pull back on the modier quick
release on the top of the ash unit to release the mount lock and rotate the softbox counter-clockwise
Intert offers a variety of light modiers as well as Bowens® mount speed rings to make your favorite
modiers compatible.
NOTE: Softboxes larger than 60” should be used with a yoke. The yoke will support the heavy
weight of the softbox. Failure to use a yoke may result in damage to the modier mount and/or
light stand mount
www.intertphotographic.com 4