Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 9
3. Disconnect the battery. Note that depending on the battery model the connec-
tors may be located differently.
4. Remove the battery from the holder.
In case a battery BS131 (12 V / 18 Ah) in an ATS1640 housing is used, it is
required to have double insulation in place. Use adequately insulated wires for
PSTN cabling, and make use of heat shrink.
Dispose of the battery as required by local ordinances or regulations.
See the specifications for your product or contact technical support for
information on replacement batteries.
To Next Page
Loading...
