Interlogix Advisor Advanced ATS1000A-MM - Page 227

Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 217
Group
Event
#
Event description
Notes
FTCTAMPER
38
Tamper and FTC
A tamper alarm active while FTC
present
CHIME
39
Chime
Active for 2 sec when zone with
chime option is active
PSCHIME
40
Chime during part
set
Active for 2 sec when zone with
chime option is active during
part set
USCHIME
41
Chime during unset
Active for 2 sec when zone with
chime option is active during
unset
ZNACTIVE
42
Zone active
At least one zone in the area is
in active state
ZNINHIBIT
43
Zone inhibit
At least one zone in the area is
inhibited
ZNISOLATE
44
Zone isolate
At least one zone in the area is
isolated
ZNFAULT
45
Zone fault
At least one zone in the area is
in fault state
ZNAM
46
Zone masking
At least one zone in the area is
in anti-mask alarm state
ZNTAMPER
47
Zone tamper
At least one zone in the area is
in tamper state
KEYPADTAMPER
48
Keypad tamper
A keypad assigned to the area is
in tamper state
KEYPADFAULT
49
Keypad fault
A keypad assigned to the area is
in fault state
EXPANDERTAMPER
50
Expander tamper
An expander assigned to the
area is in tamper state
EXPANDERFAULT
51
Expander fault
An expander assigned to the
area is in fault state
DURESS
52
Duress
Duress code used in the area
FSDURESS
53
Duress during full
set
Duress code used while area full
set
PSDURESS
54
Duress during part
set
Duress code used while area
part set
USDURESS
55
Duress during
unset
Duress code used while area
unset
FTCDURESS
56
Duress and FTC
Duress code used while FTC
present
CODETAMPER
57
Code tamper
Active when a keypad assigned
to the area is locked for 2
minutes due to 3 wrong PIN
entries
ENTRY
58
Area entry
Area entry time is active
EXIT
59
Area exit
Area exit time is active