Interlogix Caddx

Defines codes used to control system functions for operation.

Keys for triggering emergency alarms like Fire or Police response.

List of system functions that can be programmed by the user or installer.

Configuration of time delays for entry and exit door events.

Details and descriptions for each zone within the security system.

Allows a delay in reporting to the central station for specific events.

The level of access an individual has when using the alarm panel.

Location where alarm data is sent during an alarm report.

Keypad sounds a ding-dong when an entry/exit door is opened.

User codes or Function codes for system operation and control.

Special code sent to central station indicating duress without alarm.

System can be armed with zones open, indicated by ready light.

4 or 6-digit code programmed by installer to operate a device.

Allows user to bypass multiple zones with a single operation.

Instant alarm for doors or delay for entry/exit without triggering alarm.

Master arm/disarm code that can program other user codes.

System divided into multiple areas controlled by users.

The outer edge of the protected area.

Arm system by double pressing AWAY, STAY, or NIGHT key.

4 or 6-digit entry code used to arm or disarm the system.

Indicates abort delay time or communication process status.

Indicate armed modes or flash after an alarm event.

Illuminated when zones are bypassed, indicating a change in security.

Indicates if the door chime feature is currently on or off.

Indicates a fire zone fault or a critical trouble condition.

Shows primary power status or a low battery condition.

Indicates system readiness to arm or force arm.

Indicates the system requires service or has a fault.

Shows zone status: bypassed, alarm, fault, or trouble condition.

Steps to arm the system when no one is present at the premises.

Steps to arm the system when users are present inside the premises.

Feature to arm the system by pressing a key twice for convenience.

How to switch between different arming modes once the system is armed.

Procedure to disarm the security system using a valid code.

Stops communication of abortable reports when activated.

How to enable or disable the door chime feature for entry/exit.

Steps to manually bypass specific security zones from activation.

Bypass all zones designated as group bypass zones simultaneously.

Procedure to manually unbypass previously bypassed zones.

How to add, modify, or delete user access codes.

Adjusting the sounder volume and tone for keypad feedback.

Reviewing zones that caused the last alarm event.

Performing system tests like battery, communicator, or siren.

Resets smoke detectors, zone troubles, and zone tampers.

Setting the current date for the system's internal clock.

Configuring the system's current time of day.

Adjusting the illumination level of keypad buttons.