EN 4 Installation Manual
Features
This section describes the camera features.
Supports TCP/IP, HTTP, DHCP, DNS, DDNS, RTP/RTSP, PPPoE, SMTP,
NTP, UPnP, ICMP, IGMP, SNMP, FTP, 802.1x, QoS, HTTPS protocols
Programming and setup through a browser interface
Live viewing over the network
50/60 Hz selectable flicker control
120dB Wide Dynamic Range (WDR models only)
Motorized lens with zoom function
Auto focus
Supports remote upgrades and maintenance
H.264 video compression with dual capability
Supports HD (5MPX, 3MPX and 1.3MPX models), VGA,
IP66 weather proof
Micro SD card for local storage (dome cameras only)
Designed to ONVIF and PSIA open standards
Installation
This chapter provides information on how to install the cameras.
Installation environment
When installing your product, consider these factors:
• Electrical: Install electrical wiring carefully. It should be done by qualified
service personnel. Always use a proper PoE switch or a 12 VDC UL listed
Class 2 or CE certified power supply to power the bullet camera, and a
proper PoE / PoE+ switch, a 24 VAC UL listed Class 2, or CE certified
power supply to power the camera. Do not overload the power cord or
adapter.
• Ventilation: Ensure that the location planned for the installation of the
camera is well ventilated.
• Temperature: Do not operate the camera beyond the specified
temperature, humidity or power source ratings. The operating temperature of
the camera is between -10 to +60°C (14 to 140°F). Humidity is below 90%.
To Next Page
Loading...
Need help?
General
