Intermatic RC2263BE User Manual

RC2000 SERIES
REMOTE CONTROLS
INSTALLATION
OPERATION &
SERVICE MANUAL
AIR OPERATED CONTROLS FOR POOL - SPA COMBINATIONS
Suitable for Pool Equipment Control and for Direct Connection of Underwater Lights
Model: RC2263E Control Center / Model: RC2263BE Control Panel
One Button Control for Single or Two Speed Filter Pump, Blower Heater and Valves
FILTER PUMP: 1 HP - 120V, 2 HP - 240V; AIR BLOWER: 1 HP - 120V, 2 HP - 240V.
VALVE ACTUATOR: 24V up to 3 Actuators
Many of today’s pools and spas utilize the advantages of a single
electrical control panel, containing all the necessary components
for the safe, cost effective and automatic operation of a pool or spa.
Model RC2263E is designed to operate the shared equipment, like
the pump, filter and the heater of a Pool-Spa combination safely
from the spa side with only one air button. In addition, the Air
Blower of the SPA can be controlled by the same air button as
shown in the chart below.
The 24 hour timer turns ON the filter pump and automatically filters
and, if so set, heats the pool water on a daily schedule. In addition,
by the push of the #3 air button at the spa side, the Control turns
ON the pump, the heater and rotates the valves thus allowing the
water to circulate in the spa. The Control also features a selector
switch for the heater. The switch has three positions and it can be
set to hea
t the w
a
ter either in the spa only or both in the spa and in
the pool to tw
o different pre-selected temperatures. The third posi-
tion disables the heater. the Control also has terminals for connect-
ing a fr
eez
e or hea
ter pr
otection ther
mosta
t to its f
ilter pump con-
trol logic board.
Model RC2263BE is the same as the one described above,
except it is built into an 8 circuit 100 Amp. sub-panel.
T
he Contr
ol coordinates the operation of the various pool/spa
equipment according to the following table:
1
DANGER! TO AVOID RISK OF INJURY:
...do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.
...test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA!
Contact a qualified ser
vice technician immediately.
...always disconnect electricity before servicing this control or the equipment connected to it.
READ, FOLLOW & SAVE THIS INSTRUCTION MANUAL
GENERAL INFORMATION
EQUIPMENT Sequence 1 (Home Position) Sequence 2 Sequence 3 Sequence 4
Filter Pump
One Speed Timer ON/OFF ON ON OFF
Low/High Speed Timer Low/Off High High Low
Blower OFF OFF ON ON
Valves Set to Pool Circulation Set to Spa Circulation
Heater Pool Temperature Setting Spa Temperature Setting
RC2263BE
RC2263E

Intermatic RC2263BE Specifications

General

Brand	Intermatic
Model	RC2263BE
Category	Control Systems
Language	English

Summary

General Information

Product Models and Capabilities

Details on RC2263E Control Center and RC2263BE Control Panel, including pump, blower, and valve operation.

Critical Safety Warnings

Essential safety precautions to prevent injury, including supervision, ground fault testing, and electrical disconnection.

Equipment Operation Coordination

Explanation of how the control system coordinates pool and spa equipment based on programmed sequences.

Important Safety Instructions

General Safety Precautions

Mandatory safety guidelines for installation and operation, including electrical codes and grounding.

Installation

Installation Guidelines and Wiring

Instructions for mounting, conduit runs, high/low voltage connections, PC board access, and air hose connections.

Setting and Operating Instructions

Setting the Timer and Clock

Procedures for setting the time of day and programming ON/OFF times for the equipment.

Operation

Program and Operation Overrides

How to cancel/change programs, perform one-time overrides, and permanent operation mode changes.

Spa Mode and Heater Operation

Instructions for activating spa mode via air button and setting the heater control switch.

Troubleshooting

Common Issues and Corrective Actions

A guide to diagnosing and resolving common operational problems with the control system.

Enclosure Details

Dimensional Drawings

Diagrams showing the physical dimensions of the RC2263BE and RC2263E control units.

Wiring Diagram

Wiring Notes for Pump and Blower

Specific wiring instructions for single/two-speed pumps and blowers, including voltage configurations.

Low Voltage Board Connections

Diagrams and instructions for connecting valve actuators and thermostat sensors to the low voltage board.

Heater Wiring Configurations

Guides for connecting single and dual thermostat heaters, including jumper settings and switch positions.

One Year Limited Warranty

Warranty Terms and Limitations

Details on warranty coverage, exclusions, and procedures for service claims.