Intermec Technologies Corporation
Worldwide Headquarters
6001 36th Avenue West
Everett, WA 98203
U.S.A.
www.intermec.com
The information contained herein is provided solely for the purpose of allowing customers to operate and
service Intermec-manufactured equipment and is not to be released, reproduced, or used for any other purpose
without written permission of Intermec Technologies Corporation.
Information and specifications contained in this document are subject to change without prior notice and do
not represent a commitment on the part of Intermec Technologies Corporation.
© 2003-2007 by Intermec Technologies Corporation. All Rights Reserved.
The word Intermec, the Intermec logo, Norand, ArciTech, Beverage Routebook, CrossBar, dcBrowser, Duratherm,
EasyADC, EasyCoder, EasySet, Fingerprint, INCA (under license), i-gistics, Intellitag, Intellitag Gen2, JANUS,
LabelShop, MobileLAN, Picolink, Ready-to-Work, RoutePower, Sabre, ScanPlus, ShopScan, Smart Mobile
Computing, SmartSystems, TE 2000, Trakker Antares, and Vista Powered either trademarks or registered
trademarks of Intermec Technologies Corporation.
Throughout this manual, trademarked names may be used. Rather than put a trademark (™) symbol in every
occurrence of a trademarked name, we state that we are using the names only in an editorial fashion, and to the
benefit of the trademark owner, with no intention of infringement.
The software contained in the printer and the accompanying materials are copyrighted. Unauthorized copying of
the software, including software that has been modified, merged, or included with other software, or the written
materials is expressly forbidden without the prior written consent of Intermec. All right, title, and interest in all
copies of this software are and shall at all times remain the sole and exclusive property of Intermec. Customer
may be held legally responsible for any copyright infringement that is caused or encouraged by its failure to abide
by these terms.
There are U.S. and foreign patents pending.
Kimdura is a registered trademark of Kimberly Clark.
Kapton is a registered trademark of Dupont.
The name Centronics is wholly owned by GENICOM Corporation.
IBM is a registered trademark of International Business Machines Corporation.
27
Adjusting the Print Darkness
Use the darkness adjust control to fine-tune the darkness of print on your labels. The fine
adjustments compensate for variations in the media, the printhead, or the printer. Set the
darkness adjust control after you enter the media sensitivity number.
3440G.055
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
A Locate the darkness adjust control on the back of the printer.
B Use a small straight-slot screwdriver to adjust the print darkness:
• To increase the print darkness, turn the control clockwise.
• To decrease the print darkness, turn the control counterclockwise.
A
B
To compensate for uneven print quality, turn the bias
adjust screw as shown.
A If printing is light on right side of label, turn the
bias adjust screw counterclockwise.
B If printing is light on the left side of label, turn
the bias adjust screw clockwise.
Replace the media cover.
3
To Next Page
Loading...
Need help?
General