Intermec EasyCoder PD41 Instructions

EasyLAN Ethernet Software Instructions iii
Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Printer Firmware Requirements. . . . . . . . . . . . . . . . . . . . . . .5
Setting Network Parameters from the Printer Home Page . . .6
Setting Network Parameters with PrintSet 4 . . . . . . . . . . . . .7
Setting Network Parameters With Fingerprint and IPL
Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Setting IP Address Using ARP’n’PING . . . . . . . . . . . . . . . .10

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g