Intermec EasyCoder PD41 Instructions

EasyLAN Ethernet Software Instructions 5
Introduction
These instructions describe the various ways you can access and
set the network parameters on a PD41 printer equipped with an
EasyLAN Ethernet network card. The instructions apply equally
to a PD42 printer, but are less relevant since network parameters
can be changed directly from the printer display.
Once you have the printer home page up and running, please
refer to the EasyLAN User’s Guide (P/N 1-960590-xx) for
information on how to navigate the web interface and modify
advanced network settings.
Printer Firmware Requirements
Before you begin, confirm that the printer is running either
Intermec Fingerprint v10.x.x or IPL v10.x.x firmware. If you
have a PD41 printer, the easiest way to check the firmware
version is to print a test label (for help, see the
EasyCoder PD41
Printer User’s Guide
(P/N 1-960652-xx)). If you have a PD42
printer, information about the current firmware version is shown
in the display window when the printer is in idle mode.

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g