Appendix A — Specifications
PM4i Mid-Range Printer User’s Manual 129
Media With RFID Tags or Inlays
When printing on RFID media, special consideration must be taken
to the position and shape of the tag. Specific recommendations for
different kinds of Intermec-approved RFID media can be found on
the Intermec website at www.intermec.com. Additional information
is provided in the documentation that came with your RFID kit.
Accessories for the Printer
You can use these accessories (sold and ordered separately) with the
PM4i. To order accessories, contact your local Intermec sales
representative.
Integral Liner Takeup Unit
Use this accessory, which comes with a guide shaft, for peel-off (self-
strip) printing.
Paper Cutter
Use this accessory to cut off continuous paper-based stock or liner
between labels. You can collect the cut-off labels, tickets, or tags in an
optional tray.
If you are running Fingerprint or Direct Protocol, you can control the
paper cutter using the commands CUT, CUT ON, and CUT OFF. For
help, see the Intermec Fingerprint Command Reference Manual.
Media Supply Hub
Use the rotating media supply hub for media roll cores with an
internal diameter of 38 to 40 mm (1.5 in).
Paper Sensor
You can use the paper sensor with a rotating media supply hub to
detect when the remaining media supply has reached a preset
minimum diameter. You can set this diameter in Setup mode.
Media Roll Retainer
Use the media roll retainer with a rotating media supply hub to keep
large media rolls in place. With the media roll retainer installed, you
can only use media with a maximum width of 100 mm (3.9 in).
To Next Page
Loading...
Need help?
General