Intermec TRAKKER Antares 2420 - Page 201

Nugget
Co de 39
Troubleshooting
6-9
6
Problems While Configuring the Terminal (continued)
Problem Solution
On a T2425, you see this error message when
exiting the Configuration Menu:
Network configuration error.
Network is enabled. Terminal IP
address and Default Router
address set to the same
address. Configuration was not
updated.
The 2.4 GHz RF network is enabled and there is a problem with the
network configuration. You need to change the terminal IP address
and/or the default router address. Choose Primary Network or
Advanced Network from the Communications Menu.
The terminal IP address and the default router address are both set to
the same address. Set a valid IP address for the terminal and the
default router.
For help, see “Using RF Communications on the T2425” in Chapter 4.
If you cannot fix the addressing problem, check with your network
administrator to get the IP addresses for each RF network device.
On a T2425, you see this error message when
exiting the Configuration Menu:
Network configuration error.
Network is enabled. Terminal IP
address or Controller (Host) IP
address set to the same
address. Configuration was not
updated.
The 2.4 GHz RF network is enabled and there is a problem with the
network configuration. You need to change the terminal IP address
and/or the controller IP address (host IP address for a TCP/IP
network). Choose Primary Network from the Communications Menu.
The terminal IP address and the controller/host IP address are both set
to the same address. Set a valid IP address for the terminal and
DCS 300 or host.
For help, see “Using RF Communications on the T2425” in Chapter 4.
If you cannot fix the addressing problem, check with your network
administrator to get the IP address assigned to the terminal and the
controller or host.
On a T2425, you see this error message when
exiting the Configuration Menu:
Network configuration error.
Network is enabled. Default
Router address is not on the
terminal’s network.
Configuration was not updated.
The 2.4 GHz RF network is enabled and there is a problem with the
network configuration. You need to change the default router address.
Choose Advanced Network from the Communications Menu.
The terminal and DCS 300 (UDP Plus network) or host (TCP/IP
network) are on different networks, and the terminal is not on the
same network as the default router. When the terminal is on a different
IP subnetwork from the DCS 300 or host, you must set the Default
Router and Subnet Mask commands. Set a valid IP address for
terminal, DCS 300 or host, and default router.
For help, see “Using RF Communications on the T2425” in Chapter 4.
If you cannot fix the addressing problem, check with your network
administrator to get the IP addresses for each RF network device.