Intermec TRAKKER Antares 2420 - Timeout Delay

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Co de 39
Nugget
9-116
Timeout Delay
Purpose: If handshaking is enabled, the terminal expects a response to each message that is sent to
the host through the serial port. The timeout delay is the amount of time the terminal
waits to receive a response. When the timeout expires, the terminal tries sending the
message again. If no response is received after the terminal tries to send the message
three times, a timeout error occurs. In polling mode D, the terminal sends another poll
sequence when it resends the message.
Note: Before you can enable Timeout Delay, you must configure the EOM and
Handshake commands.
Syntax: YEn.data
where n is:
1 COM1 port
3 COM3 port
4 COM4 port
Acceptable values for data are:
05 ms
1 100 ms
2 500 ms
32 sec
4 10 sec
5 20 sec
6 40 sec
7 60 sec
Default: 10 seconds
Scan: To set the default timeout delay, scan one of these bar codes:
Timeout Delay 10 sec for COM1 Timeout Delay 10 sec for COM1
*$+YE1.4* *$+YE3.4*
*$+YE1.4* *$+YE3.4*
Timeout Delay 10 sec for COM4
*$+YE4.4*
*$+YE4.4*