TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual
Nugg
Co de 39
A-6
Pin Assignments for COM1
You should use a PC/AT compatible 8-pin D-Sub connector for the RS-232 serial cable.
Pin Signal Direction From Terminal
1 Carrier Detect (CD) Incoming
2 Received Data (RX) Incoming
3 Transmitted Data (TX) Outgoing
4 Data Terminal Ready (DTR) Outgoing
5 Ground (GND)
6 Data Set Ready (DSR) Incoming
7 Request to Send (RTS) Outgoing
8 Clear to Send (CTS) Incoming
9 Not Supported (NC) Incoming
Modem Communications
• Direct RJ11 phone connection, up to 33600 baud
• Supports Configurable Serial Protocol
•
XMODEM
or
YMODEM
protocol for data transfer
Bar Code Symbologies
• Codabar • Code 93
• Code One • Code 128
• Code 11 • Interleaved 2 of 5
• Code 16K • MSI
• Code 2 of 5 • PDF 417
• Code 39 • Plessey
• Code 49 • UPC/EAN
To Next Page
Loading...
