nuggetf
code39
Getting Started
1-21
1
3. Press
V
to choose Serial Port and then press
. The Serial Port screen appears.
242XU.156
SERIAL PORT [COM1]
Protocol:
Configurable
Baud Rate: 19200
Parity: Even
Data Bits: 7
Stop Bits: 1
` more
Flow Control:
None
EOM #1: \X03
EOM #2:
SOM: \X02
LRC: Disabled
Commands Vic Serial
Port:Enabled No TMF
Handshake: Disabled
242XU.157
OK CANCEL
4. In each field, press
W
to toggle through the field options and select a value. Once the
correct value is displayed, press
V
to move to the next field.
You must set each of the terminal’s serial port parameters to match your host
computer’s or serial device’s settings. Once they match, you can communicate
through the communications dock or optical link adapter.
5. Press
to save the changes and exit the Serial Port screen. The Communications
Menu appears.
6. Press
?
to exit the Communications Menu. The Configuration Menu appears.
7. Press
?
to exit the Configuration Menu.
8. Press
to choose Yes and save the new configuration in RAM. Once the changes
are saved, the terminal uses the new configuration.
Save new
configuration
(in RAM)?
242XU.059
Yes No
CANCEL
9. Press
?
to exit the TRAKKER Antares 2400 Menu System.
To Next Page
Loading...
