UM062TW / UM562TW UDM10010-01
14
SET-UP PROCEDURES
Customer supplied feed and exit conveyors (or rollers) must be level with the machine,
otherwise, the performance of the machine may be affected. The customer-supplied feed
conveyor (if used) should provide straight and level entry. The customer-supplied exit
conveyor (if used) should be straight and declined no more than 1/4 inch per foot away from
the machine.
2) Electrical Connection
The electrical control can be located
on either side of the Carton Sealer
for customer convenience. It
contains the green "on" push button
and the red "E-Stop" mushroom push
button, which is to be used both for
emergency stops as well as regular
halting of the machine.
Figure 5
An eight (8) foot strand three phase power cord with plug is provided for 115 V, 60 Hz, 15
Ampere electrical current. The servicing receptacle must be properly grounded. Before the
machine is plugged into the receptacle, ensure that all materials are removed from the
machine. The electrical control is protected with an automatic circuit breaker with resettable
overload.
To Next Page
Loading...