Interpack IPG USA 20-B - Set -U P Procedures

To Next Page

To Previous Page

UM062TW / UM562TW UDM10010-01

SET-UP PROCEDURES

B) Tape Threading

ARNING! THE KNIFE CONTAINED IN THE TAPE HEAD IS EXTREMELY SHARP. USE

CAUTION WHEN REMOVING THE BLADE GUARD AND THREADING THE

TAPE TO AVOID PERSONNEL INJURY.

To thread the Tape Head, no special tools are required.



 Remove the Tape Head by grasping the tape application rollers and lifting straight up.

 Pull approximately twelve (12) inches from the roll and fold in half lengthwise. This

allows you to thread the tape without it adhering to the guide and clutch rollers inside

the Tape Head.

 Follow the tape-threading diagram on the side plate of the HSD



2000-ETII Tape

Head. Refer to your Tape Head manual for further information if required.

 Turn the blade guard away from the knife in the Tape Head.

 Cut off the folded tape.

 Replace the lower Tape Head to its initial position.