10
EN - INSTRUCTIONS FOR THE DISPOSAL OF APPLIANCES FOR DOMESTIC USERS
(Applicable in countries in the European Union and those with separate waste collection systems)
This mark on the product or documentation indicates that this product must not be disposed of with other
household waste at the end of its life. To avoid any damage to health or the environment due to improper
disposal of waste, the user must separate this product from other types of waste and recycle it in a responsible
manner to promote the sustainable re-use of the material resources.
Domestic users should contact the dealer where they purchased the product or the local government office
for all the information regarding separate waste collection and recycling for this type of product. Corporate
users should contact the supplier and verify the terms and conditions in the purchase contract. This product
must not be mixed with other commercial waste.
This product has a battery than cannot be replaced by the user. Do not attempt to open the device to remove
the battery as this could cause malfunctions and seriously damage the product. When disposing of the
product, please contact the local waste disposal authority to remove the battery. The battery inside the
device was designed to be able to be used during the entire life cycle of the product
EN - Cellularline S.p.A., declares that this Bluetooth headset complies with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following address: www.cellularline.com/_/
declaration-of-conformity
Cellularline S.p.A., also declares that this Bluetooth headset complies with the RoHS Directive 2011/65/EU.
SAR is measured with the device at 0 mm to the body, while transmitting at the highest certified output power
level in all frequency bands of the device. The maximum SAR value is 1.75 W/kg (head/body) averaged over
10 gram of tissue.
WARNING: To prevent possible hearing damage, do not listen at high volume levels for long periods. Only use
provided headset.
Cap. 8 – AUX
Interphone AVANT can play music from a NON-Bluetooth® devices (smartphones, MP3 players etc.) via
jack 3.5 mm. To play music it is necessary use the proper micro-USB/jack 3.5mm cable (optional ref.
INTERPHOAUXCABLE) to connect AVANT with NON-BLUETOOTH device.
8.1 AUX Music Streaming
Activate/deactivate
Press the button until the first beep (1,5 seconds)
Start/Stop Music sharing (from unit 2)
Press the UP button until the second beep to start/stop
music sharing with unit no. 3.
Press the DOWN button until the second beep to start/
stop music sharing with unit no.1.
AUX Music streaming will be in background mode if intercom conversation is active, at the volume set
with the relevant MIX Level parameter (chap. 3.1).
Cap. 9 – AUDIO EQUALIZER
Interphone AVANT is equipped with several set equalization to enhance your music experience.
If you are listening to FM RADIO, MUSIC streaming or AUX MUSIC streaming you can select your prefer-
red equalization setting between 5 choices.
Change equalization settings
Press the button until the second beep (2 seconds) to
change from: “Flat”-“Rock”-“Pop”-“Reggae”- “Techno”
Each pression of button
until the second beep change
a setting, regardless of audio source.
1 2 3
TECHNICAL CHARACTERISTICS
Bluetooth
®
compliance: Bluetooth
®
v. 5 - Class II
Supported Bluetooth profiles: HFP A2DP AVRCP
Frequency: 2.402 – 2.480GHz
Power: 18dBm EIRP / 10dBm EIRP
Operating temperature: 0 - 45°C
Charging temperature: 10 - 40°C
Dimensions mm: 55x85x25
Weight: 66 g
Capacity: Up to 10 meters
Talk time: 20 h
Stand-by time: 500h with voice command off
Charging time: 1,5 h
Battery type: Lithium-ion rechargeable
Federal Communications Commission (FCC) Statement
Innovation, Science and Economic Development Canada (ISED) Statement
15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the
equipment.
15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC/ISED rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures :
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules and ISED licence-exempt RSS standard(s)
Operation is subject to the following two conditions :
1)This device may not cause interference and
2)This device must accept any interference, including interference that may cause undesired operation of the device.
FCC/ISED RF Radiation Exposure Statement :
This equipment complies with FCC/ISED radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for
satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
To Previous Page
Loading...
