6
CAP. 3 – SETTINGS
Enter settings mode:
With the device turned on, press and hold the UP button (<) until you hear the message “SETTINGS”. The
LED will be purple.
Changing the settings:
Pressing each button will change a parameter, according to the figure shown below.
Save the selected settings:
To save the parameters set simply exit the settings mode by keeping pressed the UP button (<) until the
third beep. The LED will flash blue.
3.1 System settings
• LANGUAGE SELECTION: each press of the button selects a different language for the voice guidance.
• MIX LEVEL: each press sets the volume of source in background during intercom, on a value between
Low/ Medium/High/Off.
• AUTOMATIC VOLUME (ON/OFF): the device can automatically adjust the listening volume, depending
on the environmental noise. The function can be disabled, in which case the user will manually adjust
the volume. The maximum audio level possible can be obtained with the AUTOMATIC VOLUME OFF.
In order to reach the maximum level, the automatic volume must be disabled (OFF)
• HD INTERCOM /GROUP INTERCOM: HD intercom increase the quality of the voice during a two -way
intercom. Tale funzione non è utilizzabile durante la conferenza multi utente (da tre a otto utenti),
disattivare INTERCOM HD commutando su INTERCOM DI GRUPPO, per partecipare ad una conferenza
multi utente.
• ERASE PAIRINGS: press this button for 5 seconds to delete from the memory all previously paired
Bluetooth devices.
• RDS On/Off: this service allows the device to tune to an alternative frequency when the signal beco-
mes too weak. Each press of the button activates/deactivates the function.
• PHONE CALL/GPS SHARING: If a phone call is received, the device can share the phone call with another
previously paired interphone (see Chap. 5.3). The function is deactivated by default. Each press of the
button activates/deactivates the function. Once activated, this function also allows sharing of GPS na-
vigator indications with another intercom.
• VOICE COMMANDS: the voice commands are activated or deactivated each time the button is pressed.
CAP. 4 – INTERCOM
The device enables the interphone communication (function named “INTERCOM”) across multiple devi-
ces in conference (several people talking at once).
4.1 Pairing
Before starting the communication between intercoms it is necessary to perform pairing of the various
devices. This process will only need to be performed once. Subsequently the interphone will automa-
tically recognise the previously paired devices. AVANT Interphone is compatible with the entire INTER-
PHONE range (including the previous series) and with the ANYCOM function. It is also compatible with
the interphones of other manufacturers.
If a device already has two intercoms paired, performing a third pairing will erase the pairing
with the first device paired.
4.1.1 Automatic pairing (GENIUS PAIRING™)
The GENIUS PAIRING™ feature allows the fully automatic pairing of up to 8 AVANT Interphone units.
1. Arrange the OFF units (maximum 8) next to one another as shown in the figure.
2. On the first unit to the left, press the button together the button
>
(UP) until the LED fleshes red/
green. The procedure will end automatically when the last unit has returned to stand-by mode (blue
LED every three seconds). All the units are now paired.
3. To start the conference between the recently paired unit follow below points 4.2 / 4.3 / 4.4.
Voice Commands
On/O
Language selection
Guide and Voice Commands
Phone(GPS) sharing
On/O
Audio Mix Level
Low/Medium/High/O
RDS
On/O
Automatic Volume
On/O
Erase Pairings
(5” press)
High Denition Intercom /
Group Intercom
To Next Page
Loading...
