Interroll 138i - Installation Declaration

Interroll Drum motor series i, S, S/A, D
Appendix
Version 4.1 (06/2015) en-US
Translation of original instruction manual
111
Installation declaration
In accordance with the EC Machinery Directive 2006/42/EC, Appendix II B.
The manufacturer:
Interroll Trommelmotoren GmbH
Opelstr. 3
D - 41836 Hueckelhoven/Baal
Germany
hereby declares with sole responsibility that the product range
• Drum motor i-series
• Drum motor S-series
• Drum motor S/A-series
• Drum motor D-series
is not a ready-to-use machine as defined by the EC Machinery Directive, but it complies with the
following requirements according to Appendix I of this directive:
1.1.2, 1.1.3, 1.1.5, 1.5.8, 1.5.9, 1.6.4, 1.7.2.
The special technical documents mentioned in Appendix VII B have been prepared and will be
sent to the responsible authority if required.
Applicable EC Directives:
• Machinery Directive 2006/42/EC
• EMC Directive 2004/108/EC
• RoHS Directive 2002/95/EC
Applicable harmonized standards:
• EN ISO 12100:2010-03
• EN 60034-1:2010/AC: 2010
• EN 60034-5:2001/A1:2007
• EN 60034-6:1993
• EN 60034-11:2004
• EN 60034-14:2004
• EN 60204-1:2006/AC: 2010
Person authorized to prepare the technical documents:
Holger Hoefer, Interroll Trommelmotoren GmbH, Opelstr. 3, D - 41836 Hueckelhoven, Germany
Important Note! The incomplete machine may only be put into operation if it has been
determined that the overall machine/system, which the incomplete machine is to be installed,
meets the requirements of this directive.
Hueckelhoven - April 21, 2015
Dr. Hauke Tiedemann
(Managing Director)
(This declaration of conformity can be obtained at www.interroll.com, if needed.)