EasyManua.ls Logo

Intertek TASMAN EP & HP - Warranty

Intertek TASMAN EP & HP
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 66 of 80
CONDITIONS AND LIMITATIONS (continued)
In the first year only, this warranty extends to the repair or replacement of warranted parts, which are
defective in material or workmanship provided that the product has been operated in accordance with
the operation instructions and under normal conditions.
After the first year, Inca Metal Cutting may, at its discretion, fully discharge all obligations with respect
to this warranty by refunding to the original warranted purchaser the wholesale price of any warranted
but defective part(s).
Notwithstanding any provisions contained in this warranty, Inca Metal Cutting’s responsibility under
this warranty is defined as above and it shall not in any event extend to any incidental, consequential
or indirect damages.
This warranty defines the obligations and liability of Inca Metal Cutting with respect to the Inca Metal
Cutting gas fireplace and any other warranties expressed or implied with respect to this product, its
components or accessories are excluded.
Inca Metal Cutting neither assumes, nor authorizes any third party to assume, on its behalf, any other
liabilities with respect to the sale of this product. Inca Metal Cutting will not be responsible for: over
firing, downdrafts, spillage caused by environmental conditions such as rooftops, buildings, nearby
trees, hills, mountains, inadequate vents, excessive venting configurations, insufficient make up air,
or negative air pressures which may or may not be caused by mechanical systems such as exhaust
fans, furnaces, clothes dryers, etc.
Any damages to fireplace, combustion chamber, brass or chrome trim or other component due to
water, weather damage, long periods of dampness, condensation, damaging chemicals or cleaners
will not be the responsibility of Inca Metal Cutting.
The bill of sale or copy will be required together with a serial number and a model number when
making any warranty claims from your authorized dealer.
Inca Metal Cutting reserves the right to have its representative inspect any product or part thereof
prior to honoring any warranty claim.

Related product manuals