To Next PageTo Next PageWhat to do if there is no LED display on my Intex device?
If there is no LED display on your Intex device, ensure the cell cord is firmly plugged into the cell housing receptacle and reset the RCD.
What to do if Intex Swimming Pool filter motor fails to start?
First, ensure the power cord is securely plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter, or RCD. If the RCD circuit breaker has tripped, reset it. If it repeatedly trips, your electrical system may have a defect, so turn off the breaker and consult an electrician. The motor may also be too hot, in which case you should let it cool down before restarting. Finally, check if the system is in stand-by/power saving mode.
Why is my Intex Swimming Pool filter not pumping water or flow is very slow?
A slow water flow could be due to several reasons. Check for clogged inlet or discharge and clear any obstructions in the intake hose. Look for air leaks on the intake line and tighten hose nuts, inspect hoses for damage, and check the pool water level. If the pool is excessively dirty, clean the pre-filtering basket more often. Backwash the filter if the sand media is clogged with dirt. Ensure the nozzle is at the upper position of the pool inlet and the strainer at the lower position of the pool outlet. Remove about 1” of sand if there's crusting or caking on the filtering sand surface. Also, remove any pool vacuuming device attached to the system line. Finally, ensure the inlet threaded air connector is connected to the pool inlet upper hole.
What to do if my Intex Swimming Pool has insufficient chlorine?
Several factors can lead to insufficient chlorine levels. One potential cause is chlorine loss due to intense sunlight exposure. Using a pool cover when the pool is not in use and/or when the unit is operating can help. If the bather load has increased, increasing the daily Saltwater System operating time may be necessary. Also, a clogged or dirty electrolytic cell can be the culprit, so remove the cell for inspection and clean it if necessary. High UV level exposure can also be a factor; in this case, cover the pool with a pool cover for 2 days with the device running and then test the water using the test strips. If the pool is clean and clear, add stabilizer to the water and then test the water with the device running.
What to do if my Intex Swimming Pool filter doesn’t clean the pool?
If your filter isn’t cleaning the pool effectively, several factors could be at play. Ensure that the chlorine and pH levels are properly adjusted. Make sure there is filter sand in the tank. Set the 6-way valve to the 'FILTER' position. If the pool is excessively dirty, operate the filter for longer periods. For dirt or sand on the pool floor, use an Intex pool vacuum. Lastly, check the basket, as it may be restricting the water flow and needs cleaning.
How to fix a leaking hose on my Intex Swimming Pool?
General| Model | ECO15220-1 |
|---|---|
| Category | Swimming Pool Pump |
| Power | 1.5 HP |
| Voltage | 220-240V |
| Frequency | 50Hz |
General safety guidelines and precautions.
Rules for supervising weak swimmers and non-swimmers.
Recommendations for pool barriers and alarms.
Essential rescue equipment and communication tools.
Guidelines for responsible and safe pool usage.
Key considerations for choosing and preparing the pool location.
Proper water balance and sanitizer use for liner longevity.
Common pool problems, their causes, and solutions.
Step-by-step guide to draining and storing the pool.
