How to get rid of algae in my Intex GRAPHITE GRAY PANEL POOL SET 15'8" Swimming Pool?
If you have algae in your Intex Swimming Pool, super chlorinate with shock treatment and correct the pH to your pool store’s recommended level. Vacuum the pool bottom and maintain the proper chlorine level.
Why is the water in my Intex GRAPHITE GRAY PANEL POOL SET 15'8" colored?
Colored water in your Intex Swimming Pool may be caused by copper, iron, or manganese in the water being oxidized by the added chlorine. Adjust the pH to the recommended level, run the filter until the water is clear, and replace the cartridge frequently.
How to clean sediment on the bottom of my Intex Swimming Pool?
Sediment on the bottom of your Intex Swimming Pool is likely due to heavy use. Use an Intex pool vacuum to clean the bottom of the pool.
How to remove surface debris from my Intex GRAPHITE GRAY PANEL POOL SET 15'8" Swimming Pool?
If there is surface debris in your Intex Swimming Pool, especially if the pool is too close to trees, use an Intex pool skimmer.
What to do if there is floating matter in my Intex GRAPHITE GRAY PANEL POOL SET 15'8" Swimming Pool?
If you observe floating matter in your Intex Swimming Pool, it may be due to high pH levels (“hard water”), low chlorine content, or foreign matter in the water. Correct the pH level (consult your pool dealer for advice), check for proper chlorine level, and clean or replace your filter cartridge.
What to do if my Intex Swimming Pool has a chronic low water level?
If your Intex Swimming Pool has a chronic low water level, it could be due to a rip or hole in the pool liner or hoses. Repair it with a patch kit, finger-tighten all caps, and replace the hoses.
How to fix a leaking inlet treaded air connector / air jet valve on my Intex GRAPHITE GRAY PANEL POOL SET 15'8" Swimming Pool?
If the inlet treaded air connector or air jet valve is leaking on your Intex Swimming Pool, it may be due to several reasons: the plunger valve is not well-fitted, the air jet valve is not tight and facing up, the air jet valve internal seal is blocked or dirty, or the air jet valve is broken. Here are some possible solutions: * Tighten or reinstall the plunger valve. * Tighten the air jet valve and make sure it’s facing up. * Turn the pump ON and run for a few seconds, then turn OFF, repeat 3 times. * Remove the air jet valve, flush dirt out with water, and replace the valve back. * Replace with a new air jet valve.
Crucial safety warnings about supervision, drowning prevention, and electrical hazards.
Categorized safety rules for diving, drowning, and suction fittings.
Guidelines for choosing a suitable outdoor location for the pool installation.
Step-by-step guide to preparing the ground for pool installation.
Proper techniques for water testing and treating the pool water.
General| Brand | Intex |
|---|---|
| Model | GRAPHITE GRAY PANEL POOL SET 15'8" |
| Category | Swimming Pool |
| Language | English |
To Next Page