Intex GRAPHITE GRAY PANEL POOL SET 15'8" - Pool Enclosure Setup

120
PO
SAVE THESE INSTRUCTIONS
(120PO) ENGLISH 7.5” X 10.3” PANTONE 295U 10/10/2018
English
Page 15
POOL ENCLOSURE SETUP
Oncethepoolhasbeenfilledwithwater,andithasbeenconfirmedthatitiscompletelylevelandthatall
verticallegsarepositionedinthemiddleofeachpatioblock,proceedwiththeassemblyofthepool
enclosure.
1. Top clamp installation
 • Fastenatopclamp
(16) to the T-joint of the pool frame from the underneath. Ensure the two bolts on
top clamp are facing upward. Repeat the procedure until all the top clamps are fastened to the T joints
  ofthepoolframe(seedrawings8.1&8.2).
2. Bottom cap and bottom rail installation
 • Placeabottomcap
(25) on the ground and align it with the leg cap. Ensure that the threaded side hole
in the bottom cap is facing outward. Place all bottom caps in position.
 • Startingatanylocation,butalwaysworkinginthesamedirection,connectabottomrail
(24) in between
two bottom caps
(25). Ensure the pre-drilled holes on the bottom rail hook through the knobs on the
  bottomcap.Repeatthisprocedureinacircularfashionuntilallthebottomrailsandbottomcapshave
been connected. Adjust the distance of the bottom cap to the leg cap by estimating that the support
post
(17)
willstandverticalafteritisinstalled(seedrawings9.1&9.2).
3. Support post installation
 • Removethecardboardinsertsfromthebothslidesofeachsupportpost.
 • Insertthesupportpost
(17) into the bottom cap (25). Lift up the support post slightly to let the slot on
the upper end of the support post hook onto the ridge at the top clamp. Push downward to ensure the
  supportpostisconnectedfirmlywiththetopclampandinsertedinthebottomcap(seedrawings10.1,
  10.2&10.3).
 • Repeattheseproceduresuntilallthesupportpostsarejoinedtothetopclampsandbottomcaps(see
  drawing10.4).
8.1 8.2
9.1
9.2
10.1
10.2