To Next PageTo Next PageHow to fix Intex Krystal Clear 636G filter motor that fails to start?
If your Intex Swimming Pool Pump filter motor isn't starting, ensure the filter cord is plugged into a 3-wire outlet protected by a Class A Ground Fault Circuit Interrupter, or RCD. If the GFCI/RCD circuit breaker has tripped, reset it. If it repeatedly trips, turn off the breaker and consult an electrician. Also, the motor may be too hot; allow it to cool down.
Why is my Intex Krystal Clear 636G not pumping water or has very slow water flow?
If your Intex Swimming Pool Pump doesn’t pump water or the water flow is very slow, clear any obstructions in the intake hose. Check for air leaks on the intake line by tightening hose nuts and inspecting for damage. Also, replace the cartridge if there's scale or buildup. Clean the cartridge more often if the pool is excessively dirty. Ensure the nozzle is at the upper position of the pool inlet and the strainer at the lower position of the pool outlet.
What to do if my Intex Krystal Clear 636G doesn't work?
If your Intex Swimming Pool Pump doesn’t work, fill the pool to the correct water level and clean the strainer screens at the pool inlet. Tighten hose nuts and check for hose damage to address any air leaks on the intake hose. Clear any sticks or leaves in the intake hose. Also, turn and pull the valve handle to the full upright position to release any air lock inside the cartridge chamber.
How to fix Intex Swimming Pool Pump top cover leaking?
If the top cover of your Intex Swimming Pool Pump is leaking, first remove the cover and check for the O-ring. Then, manually tighten the cover or air release valve to ensure they are secure.
How to remove air lock from Intex Swimming Pool Pump?
If there's an air lock in your Intex Swimming Pool Pump, open the air release valve until water starts to flow out, then close it. Also, ensure that the lower position of the pool outlet connects to the filter pump water inlet and the upper position of the pool inlet connects to the filter pump water outlet.
What causes colored water in my Intex Swimming Pool and how to fix it?
If you notice colored water in your Intex Swimming Pool, adjust the pH level to the recommended level. Run the filter until the water is clear and clean the cartridge frequently.
Why is there chronic low water level in my Intex Swimming Pool?
If you have a chronic low water level in your Intex Swimming Pool, repair any rips or holes in the pool liner or hoses with a patch kit. Also, finger-tighten all drain caps.
How to clean sediment on the bottom of my Intex Swimming Pool?
Use an Intex pool vacuum to clean the bottom of the pool.
How to remove surface debris from my Intex Swimming Pool?
Use an Intex pool skimmer.
General| Brand | Intex |
|---|---|
| Model | Krystal Clear 636G |
| Category | Swimming Pool Pump |
| Language | English |
