163
SAVE THESE INSTRUCTIONS
Page 20
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 09/18/2010
English
SALTWATER SYSTEM OPERATION
OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS
1. Start up the unit:
Plug the power cord into the electrical outlet and test the GFCI/RCD (circuit
b
reaker). Switch on the unit.
With the Filter Pump turned “ON” and operating. The green "Pump" light on the
control panel will be on and code “00” appears on the electronic control
station’s LED, indicating that the unit is in a Stand-By Mode. This is normal.
2. Unlock keypad controls:
Press and hold the button for 2 seconds until you hear a
short “beep”. Then press and hold the button for another 2
seconds until you hear the second short “beep”. The LED
flashes “00”. This procedure unlocks the keypad control
buttons.
3. Set operating hours for Saltwater System:
Increase the scheduled number of operating
hours by pressing the button . Or reduce
them by pressing the button . See the
“Operating Time Table” for the required
operating hours related to each pool size.
Press the button to select the desired
hours. You can press if you have
selected too many hours. The built-in timer
will now activate your Saltwater System, at
the same time each day, for the number of hours you have set.
NOTE: The Saltwater System will not operate if the filter pump is not operating.
4. Lock keypad controls:
Wit h the desired hour value showing, press and hold the
button for 2 seconds until you hear a long “beep”. Then press
and hold for another 2 seconds until you hear the second
long “beep”. The green “WORKING” indicator on the control
panel will light up within a few seconds to indicate that the
saltwater system has started sanitizer production. Locking the
control buttons into this setting prevents unauthorized changing
of the operating cycle.
NOTE: If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Just repeat the steps 2
through 4.
6. Test the copper concentration in the
pool water.
The Saltwater System recommends a
copper level of 0.1 to 0.2 ppm. This is
easily tested by the copper ion test strips
provided. If the test result is 0.1~0.2ppm,
go directly to step 8.
(1 to 12 hours max per cycle)
OK
0
Copper (ppm)
0.1 0.2 0.5 0.9 1.3
To Next Page
Loading...
Need help?
General
