EasyManuals Logo

Intex PureSpa SB-H20 Repair Guide

Intex PureSpa SB-H20
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Page 11
Opening the Control Base
Begin by removing 6 screws around the enclosure. Then take strength to pull out the connector. Open the
deflation outlet cap with the included bolt wrench and unscrew the one screw that link the outlet cap to
release it from the wire.
Removing 4 screws around the cover that hold enclosure
Removing 2 screws near on side, remove the panel from control bas
Release the screw and disconnect the black cord

Other manuals for Intex PureSpa SB-H20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex PureSpa SB-H20 and is the answer not in the manual?

Intex PureSpa SB-H20 Specifications

General IconGeneral
Control PanelDigital
Air Jets120
BrandIntex
TypeInflatable Hot Tub
Digital Control PanelYes
Seating Capacity4 person
Water Capacity210 gallons
Bubble Jets120
Heating SystemYes
CoverIncluded
Height28 inches
ModelSB-H20

Related product manuals