EasyManuals Logo
Home>Intex>Swimming Pool Pump>SF80220

Intex SF80220 User Manual

Intex SF80220
23 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
195A
SAVE THESE INSTRUCTIONS
(195IO) SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 07/17/2013
English
Page 19
MOTOR PRE-FILTER CLEANING AND MAINTENANCE
1. Make sure the filter pump is switched off, then disconnect the power cord from the electrical
outlet.
2. Turn both plunger valve handles fully clockwise until they stop. This closes the valve, prevents
the water from flowing out of the pool.
3. Release the pressure first by opening the
sediment release valve (19) located
on the lower side of the pre-filter housing
(see drawing 32).
4. In a counter-clockwise motion unscrew the
leaf trap cover (14), then remove the
basket (16) and leaf trap o-ring (15) from the
pre-filter housing (see drawing 33).
5. Empty and flush the basket using a garden hose, may use a plastic brush to remove deposits
from the basket. Do not use metal brush.
6. Clean and rinse the inside of the pre-filter housing and the leaf trap O-ring with a garden
hose.
7. Reinstall the leaf trap O-ring, basket and leaf trap cover to the pre-filter housing.
8. Close the sediment release valve (19).
1
2
32
33
19
14
15
16
35

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex SF80220 and is the answer not in the manual?

Intex SF80220 Specifications

General IconGeneral
BrandIntex
ModelSF80220
CategorySwimming Pool Pump
LanguageEnglish

Related product manuals