Part No. 1118394 25 Rehab Shower Commode Chair
ARMS SECTION 8
Section 8 - Arms - includes the following:
Removing/Installing Swing-Back Arms
Positioning Swing-Back Arms
Replacing Armrest Pad
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may occur.
ARMS
REMOVING/INSTALLING SWING-BACK ARMS (FIGURE 1)
REMOVING
1. Swing arm back. Refer to
POSITIONING SWING-BACK ARMS in this section of
the manual.
2. Remove the mounting screw and locknut that secure the swing-back arm to the arm
mounting bracket on the frame.
3. Remove the arm and arm pivot.
4. If necessary, repeat STEPS 1-3 for the other arm.
INSTALLING
1. Install swing-back arm and arm pivot on the arm mounting bracket with mounting
screw and locknut. Securely tighten.
2. Lock the swing-back arm by pushing the arm down into the socket until and audible
"click" is heard.
3. If necessary, repeat STEPS 1-2 for the other swing back arm.
Mounting Screw
Locknut
Arm Pivot
Swing Back Arm
Arm Mounting
Bracket
FIGURE 1 - REMOVING/INSTALLING SWING-BACK ARMS
Frame
To Next Page
Loading...
