Invacare A4 - Specifications

Part No. 1110545 7 A4™AND A4™TITANIUM
INVACARE A4
Frame Type: Tapered or "V"
Seat Width: 12 to 22-inches
Camber Width: Camber (in degrees) 036912
Add the inches listed in the
chart to the wheelchair width Rear Wheel Type:
to obtain the overall width Spoke 6-3/4 8 10 12-1/4 14-1/4
of the wheelchair at the Composite 7 8-1/4 10-1/4 12-1/2 14-1/2
widest point.
Seat Depth: 14 to 22-inches
Seat-to-Floor (approx.)*
Front: 17 to 21-inches - in 1-inch increments
Rear: Possible Rear Seat-to-Floor Rear Wheel Size
14-1/2 to 19-inches 22-inch
15-1/2 to 20-inches 24-inch
16-1/2 to 20-inches 26-inch
Back Style: Fold Down
Back Height: 8 to 20-inches - Adjustable
(8-11, 10-14, 12-16, 14-18 or 16-20-inch ranges)
Footrest: 5-inch Adjustable Height, Adjustable Angle or Tubular
Side Wheel Clearance: 1/2 to 2-1/2-inches (1-inch Standard)
Rear Axle: Quick-Release, Quad-Release
Rear Wheel Camber
Single: Custom - 0°, 3°, 6°, 9° and 12°
Dual: Custom - 0° and 3°, 0° and 6°, 0° and 9°, 3° and 6°, 3° and 9°,
3° and 12°, 6° and 9°, 6° and 12°, 9° and 12°
Rear Wheels: 22 or 24-inch Composite, Spoke or Spinergy
(24-inch Spoke Standard)
26-inch Spoke or Spinergy, 559mm Spoke or 700C Spoke
Handrims: Aluminum Welded Tab (Standard), Plastic Coated or Projections
Wheel Locks: Push to Lock, Pull to Lock, Hill Holder or Hideaway Undermount
Caster Size: 3-inch Rollerblade, 4 or 5-inch Soft Roll, 5-inch Urethane,
6-inch Urethane or 6-inch Semi-Pneumatic ("V" Front Only)
Seat Cushion: 2 or 3-inch
Back Upholstery: U240 Black (standard) or Adjustable Tension
Arms (Optional): Half (Swingaway Padded) or "T"
Weight**: 22 pounds - 16 x 16 frame, with anti-tippers, 24-inch spoke wheels,
and dual camber inserts.
Shipping Weight** (approx): 34 pounds - 15 x 15 seat frame with complete package
SPECIFICATIONS
SPECIFICATIONS
* NOTE: The seat-to-floor heights are based on pneumatic tires and pneumatic tires with flat free inserts. If
wheelchair is equipped with urethane tires, subtract 1/4-inch from the measurements listed above. All heights are
measured with properly inflated new tires. These heights can vary +1/4-inch due to tire wear. Add one (1) inch for
wheelchairs with the suspension option.
** NOTE: Subtract one (1) pound for Titanium models. Subtract one-half (1/2) pound for single camber inserts.
Add one (1) pound for wheelchairs with the suspension option.
SPECIFICATIONS