Invacare Action3 NG - Comfort Version

24
25
2.1.6. Comfort version
The Action
3
NG Comfort conguration (wheelchair for
passive user), needs a specic attachment kit to be tted to
the chair so that the chair is safe to be used as a vehicle seat,
see paragraph 4.3. The Comfort version is always delivered
in passive position (rear wheel support plate) for a better
stability.
- Comfort seat (photo 17)
It is removable allowing the folding of the wheelchair ;
simply lift the cushion and put it away, then grab the two seat
holding tubes and pull them upwards.
Repeat the operation in reverse order to unfold the
wheelchair (see paragraph 2.1.1).
The padding and outer cover of this seat will wear; please
contact your dealer for possible replacement.
Make sure the cushion is properly positioned on the 3 seat
Velcro fasteners to provide safety and comfort for the user.
Keep your ngers away from movable parts to prevent
injuries during folding and unfolding !
- Comfort backrest (photos 18 & 18A)
It is made up of a rigid shell (A) and a preformed foam
cushion (B) which is locked in place by Velcro fasteners thus
providing optimal comfort. The backrest is removable to
allow the folding of the wheelchair; loosen both buttons (C),
slide the levers (D) to the inside and disengage the hooks (E)
from their supports. Reverse the procedure to reassemble
the backrest.
It is recommended that this operation be performed
only by the attendant. Always make sure that the backrest is
locked in place for optimal safety of the user. Make sure the
backrest cushion Velcro fasteners are in good state and well
positioned. Keep your ngers away from movable parts to
prevent injuries.
Note : If you want to use the recliner function, please
ensure that the lateral belts are remove from theirs front
side and backrest supports.
Note : for maintenance of your DARTEX
®
cover, only use a
soft rag soaked with alcohol.
D
C
A
B
E
A
C
D
B
1
17
18
18A
19