To Next PageTo Next PageWhat to do if Invacare IRC5PO2 has power loss and internal status indicators are off?
If your Invacare Medical Equipment experiences a power loss, with both the red and green internal status indicators off, ensure the unit is plugged in. Turn the power switch to the ON position (I /) to begin recharging the device.
Why is my Invacare IRC5PO2 beeping continuously?
If your Invacare Medical Equipment is alarming continuously with a 'Beeeeeeeep...' sound while the power switch is on, and the concentrator isn't operating, here's what you can check: * Overheating: The unit might be overheating due to a blocked air intake. Remove and clean the cabinet filters. Also, ensure the oxygen concentrator is at least three inches away from walls, draperies, or furniture. * Insufficient power: Avoid using extension cords. Try moving the equipment to another electrical outlet or circuit.
What to do if Invacare IRC5PO2 is beeping rapidly?
If your Invacare Medical Equipment is emitting a rapid beeping alarm, consider the following: * Check for any kinks or blockages in the tubing, cannula, or humidifier. Correct any issues, clean or replace the item, and then turn the power off for 60 seconds before turning it back on. * Verify the flowmeter setting. If it's set at 0.5 L/min for Perfecto 5, reset it to the prescribed flow rate. If the prescribed flow rate is below 0.5 L/min, use the Pediatric Flowmeter IRCPF16 (Only with Perfecto 5).
Why does my Invacare IRC5PO2 Medical Equipment beep shortly and then pause?
If your Invacare Medical Equipment is emitting short beeps followed by a long pause, here are a few things to check: 1. Power cord: Ensure the power cord is properly plugged into the outlet. 2. Outlet power: Verify that the outlet has power. Inspect house circuit breakers or fuses. If the problem continues, try using a different outlet.
General| Brand | Invacare |
|---|---|
| Model | IRC5PO2 |
| Category | Medical Equipment |
| Language | English |
