Invacare meteor - Steering Column Panelling; Steering Column Adjustment Bowden Cable

Invacare
®
Meteor Service Manual
26
7.2.3 Steering column panelling
Disassembly
1. Loosen the screw connections between front and
rear steering column panelling.
2. Remove the Phillips screws.
3. Dismantle the rear steering column panelling.
4. Loosen the screw connections between front steer-
ing column panelling and the basket holder.
5. Remove the Allen screws and the basket holder.
6. Carefully remove the front steering column panel-
ling.
7. Pull out the keyswitch complete with wiring harness
from the control panel and remove front panelling.
Reassembly
1. Reassembly takes place in reverse order to disassembly.
7.2.4 Steering column adjustment Bowden cable
Disassembly
1. Dismantle the operating console (see section 7.2.2).
2. Dismantle the rear steering column panelling (see
section 7.2.3).
3. Note down the Bowden cable route (sketch).
4. Loosen the union nut on the Bowden cable at the
handle.
5. Twist the Bowden cable nut out of the handle.