11
1.6 Controlling the wheelchair using the remote
• Switch on the remote (ON/OFF button). The displays on the remote will illuminate. The
wheelchair is ready to drive.
• Set the drive level (“drive level“ button see "Layout of the remote" on page 5).
• Speed stage 1 (slow) to 5 (fast) is shown on the drive level display.
Can the electronic system programming be adapted?
The electronic controller is programmed with standard values during manufacture. Your
Invacare® dealer can carry out programming tailored to fit your requirements.
Will the wheelchair not drive after switching on?
Check the drive-away lock (see chapter "Activating / deactivating the immobilizer " on page
9) and the status bar indicator (see chapter "ON/OFF diode (status display)" on page 8.).
To Next Page
Loading...
