Inventis PICCOLO - Page 36

30
on power supply
input lines
IEC 61000-4-11
(60% dip in U
T
)
for 5 cycles.
70% U
T
(30% dip in U
T
)
for 25 cycles.
<5% U
T
(> 95% dip in U
T
)
for 5 s.
(60% dip in U
T
)
for 5 cycles.
70% U
T
(30% dip in U
T
)
for 25 cycles.
<5% U
T
(> 95% dip in U
T
)
for 5 s.
user of Piccolo
requires continued
operation during
power mains
interruptions, it is
recommended that
Piccolo be powered
from an
uninterruptible
power supply or a
battery.
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
30 A/m
30 A/m
Magnetic fields at
power frequencies
must correspond to
the levels typical of
professional
healthcare facilities.
Note:
(1)
A lock or reboot of the device with no permanent damage is acceptable
(2)
U
T
is the a.c. main voltage prior to application of the test level.
Guidance and manufacturer’s declaration – electromagnetic immunity
Piccolo is intended for use in the electromagnetic environment specified below.
The customer or the user of Piccolo should assure that it is used in such an
environment.
Immunity Test
IEC 60601
Test Level
Compl.
Level
Electromagnetic environment
– Guidance
Conducted RF
IEC 61000-4-6
3 Vrms
0.15 MHz to
80 Mhz
6 Vrms
in ISM bands
between 0.15
MHz and
80 MHz
3 Vrms
0.15 MHz to
80 Mhz
6 Vrms
in ISM bands
between 0.15
MHz and
80 MHz
Portable and mobile RF
communications equipment
should be used no closer than
30cm (12 inches) to any part
of Piccolo, including cables
specified by the
manufacturer.
Field strengths from fixed RF
transmitters, as determined by
an electromagnetic site
survey,
a
should be less than
the compliance level in each
frequency range.
b
Interference may occur in the
vicinity of equipment marked
with the following symbol:
Radieted RF
IEC 61000-4-3
3 V/m
80 Mhz to 2,7
Ghz
3 V/m
80 Mhz to 2,7
Ghz
Note 1: At 80 MHz and 800 MHz, the higher frequency range applies.