INVENTOR B2VI-18 - Remote Controller Description

Remote Controller Description
Press this button to turn on the unit. Press this button again to turn off the unit.
ON/OFF :
1
MODE :
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN, and HEAT
*
, as the following:
AUTO
COOL
DR
Y
FAN HE
AT
*
*Note: Only for models with heating
function.
2
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
+ :
Press this button to increase set temperature. Hold it down for above 2 seconds to
3
rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.
Press this button to decrease set temperature. Hold it down for above 2 seconds to rapidly
.
4
decrease set temperature. In AUTO mode, set temperature is not adjustable.
FAN :
This button is used for setting fan speed in the sequence that goes from AUTO,
,
to
then back to Auto.
,
,
Auto
Low speed
Medium speed
High speed
5
Press this button to set up & down swing angle, which circularly changes as below:
:
OFF
6
This remote controller is universal. If any command , or is sent out,
the unit will carry out the command as
indicates the guide louver swings as:
- 9 -
Operation of Remote Controller